伊寧洗地機常見事故及其處理方法

Common accidents of washing machine and their treatment

[指南資料]研究表明，自動掃地機的大部分故障是人為因素造成的，而工作環境的影響也占很大比例。如果您使用的全自動洗地機在最合適的環境中使用，則可以在正常時間使用。在這種情況下，您遇到的問題很容易解決。不要在異常的工作環境中使用該機器。接下來，讓編輯向您介紹它!

[guide materials] research shows that most of the failures of automatic sweepers are caused by human factors, and the impact of working environment also accounts for a large proportion. If the fully automatic floor washer you use is used in the most suitable environment, it can be used in normal time. In this case, the problems you encounter are easy to solve. Do not use the machine in an abnormal working environment. Next, let the editor introduce it to you!

問題1：伊寧洗地機的清洗不完整

Problem 1: cleaning of automatic floor washer is incomplete

伊寧洗地機檢查刷盤的磨損情況，必要時用同一規格的刷盤更換;在真正污穢的地面上清洗時，應使用特殊的刷盤，必要時應特別提供。

Check the abrasion of the brush disc and replace it with a brush disc of the same specification if necessary; when cleaning on the really dirty ground, use a special brush disc and provide it if necessary.

問題2：伊寧洗地機自動洗地機的吸水率不好。

Problem 2: the water absorption of the automatic washing machine is not good.

1.伊寧洗地機檢查吸力馬達開關是否開著

1. Check whether the suction motor switch is on

二.伊寧洗地機檢查吸入管是否已正確插入污水槽入口;

2、 Check whether the suction pipe has been correctly inserted into the sewage tank inlet;

3.伊寧洗地機檢查膠條是否干凈，是否還留有固體殘留物

3. Check whether the rubber strip is clean and whether there is solid residue left

4.伊寧洗地機更換斷帶，調整吸力帶的角度。為了正確使用，吸力帶的高度應根據膠帶的磨損情況調整。在清洗過程中，后帶應向后向后彎曲。

4. Replace the broken belt and adjust the angle of suction belt. In order to use it correctly, the height of suction belt should be adjusted according to the abrasion of the belt. During cleaning, the rear belt should be bent back.

5.伊寧洗地機拆卸抽吸裝置，并請將其清洗

5. Remove the suction device and clean it

6.檢查滑輪的調整情況

6. Check the adjustment of pulley

問題三：伊寧洗地機泡沫太多

Question three: too many bubbles

檢查是否使用地面泡沫清潔劑，如有必要，在污水槽中加入一些低泡沫劑，如果地面上有大量污垢，會產生大量泡沫，此時應稀釋清潔劑。

Check whether to use floor foam cleaners. If necessary, add some low foaming agents in the sewage tank. If there is a lot of dirt on the floor, there will be a lot of bubbles. Dilute cleaners should be diluted at this time.

問題4：伊寧洗地機的刷盤上沒有足夠的水。

Problem 4: there is not enough water on the brush plate of the automatic floor washer.

檢查將水輸送到刷盤的管道是否堵塞

Check whether the pipeline for water delivery to the brush disc is blocked

二.伊寧洗地機檢查水閥是否開著。

2、 Check that the water valve is open.

3.檢查水箱中的水量

3. Check the water volume in the water tank

4.檢查水過濾器是否干凈

4. Check whether the water filter is clean

洗地機疑難病"的解決方案

The solution to the difficult problems of washing machine

如果自動洗地機長期使用后保養不好，就會導致故障。為了避免在使用過程中影響正常工作，用戶必須能夠不適當地適應，及時發現問題，并解決故障。

If the automatic washing machine is not well maintained after long-term use, it will lead to failure. In order to avoid affecting normal operation in the process of use, users must be able to adapt improperly, find problems in time, and solve faults.

條件1：洗地機的污水吸收效果差。

Condition 1: the waste water absorption effect of the washing machine is poor.

1.首先，檢查電池是否足夠。

1. First, check whether the battery is sufficient.

2.污水槽頂部的膠帶是否有磨損，如有必要，更換新的吸水性膠帶

2. Check whether the tape on the top of the sewage tank is worn. If necessary, replace it with a new absorbent tape

3.如果膠帶沒有磨損，檢查帶材的位置是否相互偏離，并調整帶材與地面之間的高度。通常，后膠帶在清洗時應向后彎曲。

3. If the tape is not worn, check whether the position of the strip deviates from each other and adjust the height between the strip and the ground. In general, the rear tape should be bent back when cleaning.

4.污水槽蓋不嚴格封閉，污水管蓋不蓋好，可能導致洗地機吸力不足。

4. The cover of the sewage tank is not strictly closed, and the cover of the sewage pipe is not well covered, which may lead to insufficient suction of the washing machine.

5.如吸入管損壞，更換吸入管，如未損壞，則檢查吸入管與污水艙之間的連接是否正確。

5. If the suction pipe is damaged, replace the suction pipe. If not, check whether the connection between the suction pipe and the sewage tank is correct.

6.污水吸入管內有垃圾，導致堵塞，并可使洗地機不能吸收水，因此應清除堵塞。

6. There is garbage in the suction pipe of sewage, which causes blockage and prevents the scrubber from absorbing water. Therefore, the blockage shall be removed.

7.吸水機損壞或內線短路，這種情況更麻煩，最好聯系廠家申請售后。

7. The water absorption machine is damaged or the internal wire is short circuited, which is more troublesome. It is better to contact the manufacturer to apply for after-sales service.

條件二：洗地機不動

Condition 2: the floor washer does not work

電池可能沒電了

The battery may be dead

2.檢查刷盤在地面上的壓力是否過大。如果是，適當調整刷盤高度，降低壓力。

2. Check whether the pressure of brush disc on the ground is too large. If yes, adjust the brush disc height properly to reduce the pressure.

3.檢查萬向盤是否能靈活轉動。如果很難轉動，萬向盤可能會被什么東西纏住。

3. Check whether the universal disk can rotate flexibly. If it's hard to turn, the gimbal may get caught in something.

4.連接萬向盤的軸承生銹，可以添加潤滑油。

4. The bearing connecting universal disk is rusty, and lubricating oil can be added.