利川洗地機如何解決洗地機不吸水的問題

How to solve the problem that the washing machine does not absorb water

利川洗地機在許多人使用了一段時間后，他們通常會遇到機器不吸水或不干凈的情況。那么，在洗地車中造成這種情況的原因到底是什么呢?

After many people use it for some time, they usually encounter the situation that the machine does not absorb water or is not clean. So, what is the cause of this situation in the washing car?

利川洗地機我們知道，洗車可以將污水從地面吸收到機器內部，依靠抽吸電機的真空吸力將水吸收到污水槽中，如果這種吸管有漏氣或堵塞，必然會影響機器的吸水效果。

We know that car washing can absorb the sewage from the ground to the inside of the machine, and absorb the water into the sewage tank by the vacuum suction of the suction motor. If this kind of suction pipe has air leakage or blockage, it will inevitably affect the water absorption effect of the machine.

利川洗地機高梅建議，對于不吸水或不清潔，可按以下步驟加以檢查：

Gao Mei suggested that for non water absorption or non cleaning, the following steps should be followed:

第一，吸入電機是否工作，如果沒有，請檢查吸水機保險是否保險絲，如果保險不是保險絲，應檢查吸水機電路或吸水機;

First, whether the suction motor works, if not, please check whether the safety fuse of the water suction machine, if not, check the circuit or the water suction machine;

2.如果吸水管的吸水率正常，但吸水管不干凈，請檢查吸水管是否密封嚴密，吸入管或氣泡網中是否有異物堵塞，通風不良，整個吸水帶是否與地面平行，吸水性膠條是否損壞，或是否已達到使用壽命。

2. If the water absorption rate of the suction pipe is normal, but the suction pipe is not clean, please check whether the suction pipe is tightly sealed, whether there is foreign matter blocking in the suction pipe or bubble net, whether the ventilation is poor, whether the whole suction belt is parallel to the ground, whether the water absorption rubber strip is damaged, or whether it has reached the service life.

利川洗地機高梅編輯認為，在正常情況下，不干凈的吸水率問題很簡單，基本上是由于維護不當造成的，只要稍加檢查就可以普遍找出故障所在。

According to Gao Mei, under normal circumstances, the problem of unclean water absorption is very simple, which is basically caused by improper maintenance. With a little inspection, the fault can be generally found out.